Life Cycle Assessment – Opportunities for Forest Products Sector

Authors

  • Andreja Kutnar 1University of Primorska, Titov trg 4, 6000 Koper, Slovenia, 2 InnoRenew CoE, Livade 6, 6310 Izola, Slovenia
  • Callum Hill 3JCH Industrial Ecology Ltd., Bangor, Gwynedd, UK 4Norwegian Institute for Bioeconomy Research, Postbox 115, Ås 1431, Norway 5Department of Architecture and Civil Engineering, University of Bath, Claverton Down, Bath BA2 7AY

Keywords:

environmental impact, environmental product declaration (EPD), forest products, life cycle assessment (LCA), O-LCA, product category rules (PCR), S-LCA, wood

Abstract

The utilization of wood in long life products, such as construction materials in the built environment, is an
effective way to optimize the use of natural resources while also reducing negative environmental impacts.
However, the environmental benefits of timber, especially in the construction sector, are not always clearly
understood. As a renewable material, timber is available in perpetuity if it is obtained from sustainably managed
forests. Using timber in the built environment stores sequestered atmospheric carbon dioxide in long-life products
and timber can be incinerated at the end of its life (or its multiple lives) with energy recovery, thereby minimizing
demolition waste. The built environment effectively acts as an extension of the forest. The question is: how
should the environmental benefits of timber use be measured and presented? To answer that question, this
paper offers an overview of the life cycle assessment (LCA) methods the forest products sector could broadly
apply to evaluate and report the sustainability performance of wood. In addition to environmental LCA, the
paper also incorporates an overview of organizational LCA (O-LCA), and social LCA (S-LCA). Furthermore, this
paper discusses environmental product declarations (EPDs) and construction standards aiming to enable better
comparability of the environmental performance of products. This review paper concludes with a discussion of
where the opportunities for the forest products sector lie and the need for joint actions within the sector. The
importance of including the storage of sequestered atmospheric carbon dioxide into the standards assessing
the environmental impact is emphasized.

References

Audenaert, A., De Cleyn, S.H. & Buyle, M. 2012. LCA of low-energy flats using the Eco-indicator 99 method: Impact of insulation materials. Energy and Buildings, 47, pp.68-73.

Ayres, R.U. 1995. Life cycle analysis: A critique. Resources, Conservation and Recycling, 14(3), pp.199-223.

Bare, J.C., Hofstetter, P., Pennington, D.W. & De Haes, H.A.U. 2000. Midpoints versus endpoints: The sacrifices and benefits. The International Journal of Life Cycle Assessment, 5(6), pp.319-326.

Brandão, M., Levasseur, A., Kirschbaum, M.U., Weidema, B.P., Cowie, A.L., Jørgensen, S.V., Hauschild, M.Z., Pennington, D.W. & Chomkhamsri, K. 2013. Key issues and options in accounting for carbon sequestration and temporary storage in life cycle assessment and carbon footprinting. The International Journal of Life Cycle Assessment, pp.1-11.

Brankatschk, G. & Finkbeiner, M. 2014. Application of the Cereal Unit in a new allocation procedure for agricultural life cycle assessments. Journal of Cleaner Production, 73, pp.72-79.

Brunet‐Navarro, P., Jochheim, H. & Muys, B. 2016. Modelling carbon stocks and fluxes in the wood product sector: A comparative review. Global Change Biology, 22(7), pp.2555-2569.

BSI. 2008. Specification for the assessment of the life cycle greenhouse gas emissions of goods and services. BSI British Standards. ISBN, 978(0), pp.580.

CEN. 2012. EN 15804: Sustainability of construction works – Environmental product declarations – Core rules for the product

category of construction products. Brussels: CEN.

CEN. 2014. EN 16485: Round and sawn timber – Environmental Product Declarations – Product category rules for wood and wood-based products for use in construction. Brussels: CEN.

Chau, C.K., Leung, T.M. & Ng, W.Y. 2015. A review on life cycle assessment, life cycle energy assessment and life cycle carbon emissions assessment on buildings. Applied Energy, 143, pp.395-413.

Cherubini, F., Guest, G. & Strømman, A.H. 2012. Application of probability distributions to the modeling of biogenic CO2 fluxes in life cycle assessment. Global Change Biology - Bioenergy, 4(6), pp.784-798.

De Haes, H.A.U. 1993. Applications of life cycle assessment: expectations, drawbacks and perspectives. Journal of Cleaner Production, 1(3-4), pp.131-137.

Del Borghi, A. 2013. LCA and communication: Environmental product declaration. The International Journal of Life Cycle Assessment, pp.1-3.

Ding, G.K. 2008. Sustainable construction—The role of environmental assessment tools. Journal of Environmental Management, 86(3), pp.451-464.

Dong, Y.H. & Ng, S.T. 2014. Comparing the midpoint and endpoint approaches based on ReCiPe - A study of commercial buildings in Hong Kong. The International Journal of Life Cycle Assessment, 19(7), pp.1409.

Ehrenfeld, J.R. 1997. The importance of LCAs—warts and all. Journal of Industrial Ecology, 1(2), pp.41-49.

EU Regulation. 2011. No 305/2011 of the European Parliament and of the Council of 9 March 2011 laying down harmonised conditions for the marketing of construction products and repealing Council Directive 89/106/EEC.

European Commission (EC). 2013. Product Environmental Footprint Guide [PEF Guide] Annex II of Commission Recommendation of 9 April 2013 on the use of common methods to measure and communicate the life cycle environmental performance of products and organisations (2013/179/EU). Official Journal of the European Union, L124(4.5.2013), pp. 6-210.

Finkbeiner, M. 2014. Product environmental footprint—breakthrough or breakdown for policy implementation of life cycle assessment? International Journal of Life Cycle Assessment, 19, pp.266-271.

Finnveden, G. 2000. On the limitations of life cycle assessment and environmental systems analysis tools in general. The International Journal of Life Cycle Assessment, 5(4), pp.229-238.

Finnveden, G., Hauschild, M.Z., Ekvall, T., Guinée, J., Heijungs, R., Hellweg, S., Koehler, A., Pennington, D. & Suh, S. 2009. Recent developments in life cycle assessment. Journal of Environmental Management, 91(1), pp.1-21.

Forsberg, A. & Von Malmborg, F. 2004. Tools for environmental assessment of the built environment. Building and Environment, 39(2), pp.223-228.

Frischknecht, R. & Stucki, M. 2010. Scope-dependent modelling of electricity supply in life cycle assessments. The International Journal of Life Cycle Assessment, 15(8), pp.806-816.

Gala, A.B. & Raugei, M. 2015. Introducing a new method for calculating the environmental credits of end-of-life material recovery in attributional LCA. The International Journal of Life Cycle Assessment, 20(5), p.645.

Hauschild, M.Z., Goedkoop, M., Guinée, J., Heijungs, R., Huijbregts, M., Jolliet, O., Margni, M., De Schryver, A., Humbert, S., Laurent, A. & Sala, S. 2013. Identifying best existing practice for

characterization modeling in life cycle impact assessment. The International Journal of Life Cycle Assessment, pp.1-15.

Hill, C.A., 2011. An introduction to sustainable resource use. Earthscan, Routledge.

Hill, C.A.S. & Dibdiakova, J. 2016. The environmental impact of wood compared to other building materials. International Wood Products Journal, 7(4), pp.215-219.

IPCC. 2007. Climate Change 2007: Synthesis Report. Contribution of Working Groups I, II and III to the Fourth Assessment Report of the Intergovernmental Panel on Climate Change [Core Writing Team, Pachauri, R.K and Reisinger, A. (eds.)]. IPCC, Geneva, Switzerland, 104 pp.

IPCC. 2014. Climate Change 2014: Synthesis Report. Contribution of Working Groups I, II and III to the Fifth Assessment Report of the Intergovernmental Panel on Climate Change [Core Writing Team, R.K. Pachauri and L.A. Meyer (eds.)]. IPCC, Geneva, Switzerland, 151 pp.

ISO. 2006a. ISO 14040—Environmental management—Life cycle assessment—Principles and framework. International Organisation for Standardization, Geneva, Switzerland.

ISO. 2006b. ISO 14044—Environmental management—Management—Life cycle assessment—Requirements and guidelines. International Organisation for Standardization, Geneva, Switzerland.

ISO. 2006c. ISO 14025—Environmental labels and declarations—Type III environmental declarations—Principles and procedures. International Organisation for Standardization, Geneva, Switzerland.

ISO. 2007. ISO 21930— Sustainability in building construction— – Environmental declaration of building products. International Organisation for Standardization, Geneva, Switzerland. ISO. 2014.

ISO. 2014. ISO/TS 14072—Environmental management—Life cycle assessment. —Requirements and guidelines for organizational life cycle assessment. International Organisation for Standardization, Geneva, Switzerland.

Jasinevičius, G., Lindner, M., Pingoud, K. & Tykkylainen, M. 2015. Review of models for carbon accounting in harvested wood products. International Wood Products Journal, 6(4), pp.198-212.

Jungmeier, G., Werner, F., Jarnehammar, A., Hohenthal, C. & Richter, K. 2002. Allocation in LCA of wood-based products experiences of cost action E9. The International Journal of Life Cycle Assessment, 7(6), pp.369-375.

Krozer, J. & Vis, J.C. 1998. How to get LCA in the right direction? Journal of Cleaner Production, 6(1), pp.53-61.

Martínez-Blanco, J., Lehmann, A., Chang, Y.J. & Finkbeiner, M. 2015a. Social organizational LCA (SOLCA) — a new approach for implementing social LCA. The International Journal of Life Cycle Assessment, 20(11), pp.1586.

Martínez-Blanco, J., Inaba, A. & Finkbeiner, M. 2015b. Scoping organizational LCA— challenges and solutions. The International Journal of Life Cycle Assessment, 20(6), pp.829.

Monteiro, H. & Freire, F. 2012. Life-cycle assessment of a house with alternative exterior walls: comparison of three impact assessment methods. Energy and Buildings, 47, pp.572-583.

Nepal, P., Skog, K.E., McKeever, D.B., Bergman, R.D., Abt, K.L. & Abt, R.C. 2016. Carbon mitigation impacts of increased softwood lumber and structural panel use for nonresidential construction in the United States. Forest Products Journal, 66(1), pp.77-87.

Ortiz, O., Castells, F. & Sonnemann, G. 2009. Sustainability in the construction industry: A review of recent developments based on LCA. Construction and Building Materials, 23(1), pp.28-39.

Pilli, R., Fiorese, G. & Grassi, G. 2015. EU mitigation potential of harvested wood products. Carbon Balance and Management, 10(1), pp.6.

Pingoud, K. & Lehtilä, A. 2002. Fossil carbon emissions associated with carbon flows of wood products. Mitigation and Adaptation Strategies for Global Change, 7(1), pp.63-83.

Pinsonnault, A., Lesage, P., Levasseur, A. & Samson, R. 2014. Temporal differentiation of background systems in LCA: relevance of adding temporal information in LCI databases. The International Journal of Life Cycle Assessment, 19(11), pp.1843-1853.

Sala, S., Vasta, A., Mancini, L., Dewulf, J. & Rosenbaum, E. 2015. Social life cycle assessment: State of the art and challenges for supporting product policies. EUR 27624 EN.

Sathre, R. & Gustavsson, L. 2006. Energy and carbon balances of wood cascade chains. Resources, Conservation and Recycling, 47(4), pp.332-355.

Sathre, R. & Gustavsson, L. 2009. Using wood products to mitigate climate change: External costs and structural change. Applied

Energy, 86(2), pp.251-257.

Subramanian, V., Ingwersen, W., Hensler, C. & Collie, H. 2012. Comparing product category rules from different programs: Learned outcomes towards global alignment. The International Journal of Life Cycle Assessment, pp.1-12.

UNEP/SETAC. 2009. Guidelines for social life cycle assessment of products. Life-Cycle Initiative, United Nations Environment Programme and Society for Environmental Toxicology and Chemistry., Paris, France. http://www.unep.fr/shared/publications/pdf/DTIx1164xPA-guidelines_sLCA.pdf (Accessed April 15, 2016).

UNEP/SETAC. 2015. Life Cycle Initiative–Guidance on organizational life cycle assessment. United Nations Environment Programme. Paris, France. http://www.lifecycleinitiative.org/wp-content/uploads/2015/04/o-lca_24.4.15-web.pdf (Accessed April 15, 2016).

Witczak, J., Kasprzak, J., Klos, Z., Kurczewski, P., Lewandowska, A. & Lewicki, R. 2014. Life cycle thinking in small and medium enterprises: The results of research on the implementation of life cycle tools in Polish SMEs—Part 2: LCA related aspects. The International Journal of Life Cycle Assessment, 19(4), pp.891.

Downloads

Published

2017-09-15

Issue

Section

Empirical Manuscripts